The bonding strengths of a wide and varied range of materials including concrete, screeds, repair mortars, epoxy resin coatings, laminates, plastics, paints and enamels may be accurately determined using the Material Bond Tester. This technically advanced, accurate instrument is suitable for use in the laboratory, workshop and on site.
Turning handle design incorporating operating nut and detachable handles allowing use in confined spaces.
Bond Testing
Adequate direct tensile strength or bonding strength between two layers is important if repairs to concrete structures or additional overlays and screeding on existing concrete is to be structurally sound. The pull-off test as a means of projecting the compressive strength of concrete and other materials involves bonding a circular steel disc to the surface by means of an epoxy resin adhesive. A controlled tensile force is then applied to the disc, and as the strength of the bond is greater than that of the material under stress it will eventually fail in tension. From the area of the disc and the force applied at failure it is possible to calculate a nominal tensile strength for the material.
The Bond Tester Kit consists of:
- Hand operated puller.
- 0 - 25kN Dual Scale Digital Gauge
- Adjustable alignment bond stool plate with built-in levelling facility.
- Bond Stool bush.
- 10 x 75mm diameter steel discs, 20mm thick.
- 10 x 50mm diameter steel discs, 20mm thick.
- Padded carrying case
- Full operating instructions
